Setting up the scanner
You decide how the scanner responds after a scan: how long green stays on screen, whether the scanner carries on by itself, and whether sound, a flash or vibration is added. You pick one of four presets and adjust it if needed.
Step 1: Open the scanner settings
Go to Settings › Tickets and find the Scanner card. If only the shop is switched on and not tickets, the page is called Scanner. Only a system administrator can change this.
On the management page of your scanners (for an event, or the shop's pickup scanners) you see which preset applies, for example Scanner behaviour: Club night. As a system administrator you tap Change there to go straight to the settings.
Step 2: Choose a preset
Under How does the scanner respond after a scan? pick one:
- Club night – canteen, club party. This is on by default.
- Busy gate – festival, queue, several scanners.
- Checking – membership card, age check.
- Quiet hall – theatre, concert.
If your combination of the choices below differs from these, you see Custom.
Step 3: Fine-tune with More settings
Tap More settings for every option:
- After a valid scan – Continue automatically or Wait for Next. With the second, the volunteer gets a Next button after a green scan.
- Green stays on screen – Short, Normal, Long or Very long.
- Flash – Soft, Normal or Bright, and Where it flashes: The whole screen or Only the status box.
- Colours – Green, orange and red, or Colour-safe: blue, orange and purple.
- Vibration – Off, On orange and red or On every scan.
- Show extras, such as "+1 Parking", Large text and Keep screen awake (only if the device supports it).
Under Try it you see straight away what it looks like: tap Valid, Doubt or Invalid. Then tap Save.
Red and orange always stay on screen until the volunteer taps OK, and scanning is blocked while that screen is showing. You cannot turn that off. At the bar (checking off extras) there is never a Next button.
Sound and vibration on your own device
Sound is on by default, for every club. A volunteer turns it off on their own phone with the Sound on this device button at the top of the scanner card. That choice is per device and changes nothing for the others. The same goes for Vibration on this device.
Vibration works in a phone's browser (for example Chrome on Android). In the 4planning app, vibration does not work yet.
Frequently asked questions
When does a change take effect? A scanner that is already open uses the new setting once you reopen it.
Can each scanner get its own behaviour? No, the setting applies to all scanners of your environment.
Why can't I hear anything? Check that sound is on on the device itself: tap Sound on this device.
Was this helpful?
Thank you — we use this to improve the knowledge base.